Product name:

Electric Concrete Power Trowel Machine

Product brief introduction:

90cm Electric Concrete Power Trowel Machine

Product description:

This is the electric oncrete Power Trowel Machine work diameter of 90cm produced by Yuhuan Jianer machinery.

Instructions:

Main structure and working principle:

This series of four blade polishing machine adopts direct worm gear reducer to transfer power, and has the characteristics of large reduction ratio, high efficiency and compact structure.

The machine structure is shown in Figure 1 and Figure 2. The motor and gasoline engine drive the worm gear box by triangular belt, thus driving the disc rotation

To smooth out. Worm gear drive has the advantages of large torque, durable, smooth and even speed.

The biggest advantage of this machine,can achieve one machine two use, coarse wipe, fine wipe. Turn the hand wheel to adjust the Angle of the piece to reach rough or Fine.

Operating rules and matters needing attention:

1. After unpacking the new machine, first put the handle straight. Tighten the screws and nuts with a wrench, according to the height of the operator And the operation needs to tighten the nut adjustment. Turn the handwheel to the left to the end.First pull down the 2 nuts on the wire rope buckle, and put Lift the fork up, buckle the wire rope buckle again as is, and screw the two nuts tightly respectively.

2. Before operation to carefully check the zero line grounding, electrical appliances, motors, cables, etc. are intact, whether water, otherwise Must be repaired.

3. Clean the dirt on the pad in time to prevent scratches on the concrete surface during construction.

4. The machine to access the power cable must use a single cross-sectional area above the cable, and must be a ground wire 4-core cable.

5. Put the machine on the air without the wiping to the ground, switch on the power supply, and try to check the rotating direction of the wiping. Be careful! In accordance with the Rotate in the same direction as the blade, otherwise injury may occur.

6. When the swivel direction of the blade is correct, hold both hands tightly and control the handle with force, but do not press down or lift up the handle. Turn on the switch in the left hand and rotate the pad slowly until the pad rotates normally, then it can work normally.

7. When working with the blade, remove the wipe plate first, and then turn the handle wheel to the pointer direction, and the nut to 100-150cm Length, then connect the steel rope to the pressure rod below, lock it, turn the handle wheel back until the blade is turned 15° to the left The right can work normally.

8. The construction of the movement, handle up or down, the machine will move left, right, need to move forward, backward push forward or backward Pull.

9. When operating, the operator must wear soft insulation shoes, must wear insulation gloves; Otherwise it could cause harm.

10. During construction, pay attention to the temperature of the motor and reduction box should not exceed 80℃.

11. The oil in the worm gear box needs to be checked regularly. If it is lower than the oil standard, please refuel in time.

12. After each use, the machine and tools should be cleaned in time, especially the wipe should be kept clean and stored in a dry, clean and non-corrosive ring In every side.

13. When the pad is worn to 30mm, loosen the screw, turn the pad around and tighten the screw again to reach the second pair Purpose of use.

14. When the Angle of the piece changes, turn the hand wheel to adjust the Angle of the piece, so as to achieve the ideal effect of coarse and fine wiping.

15. If the construction needs to stop, please turn off the power in time.

16. When the gasoline engine stops, press the switch on the handle to stop it.

http://www.jianermachine.com/